Eaton Endurant - Rear Housing Assembly Disassembly;Assembly

114
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
20. Align pin with passage in housing until pin is fully
seated into passage.
Note: If necessary, use a soft faced hammer to lightly
tap shaft into housing.
21. Install bearing into Lower Reverse Idler Gear.
22. Install and hold Lower Reverse Idler Gear upper
washer into Main Housing.
23. While holding the upper washer, install Lower Reverse
Idler Gear, bearing and lower washer into Main Hous
-
ing.