2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
115
TRSM0950 Disassembly/Assembly | Main Housing Disassembly/Assembly
24. Install Lower Reverse Idler Gear Shaft by pushing shaft
into housing, through washers, bearing and gear.
25. Align pin with passage in housing until pin is fully
seated into passage.
Note: If necessary, use a soft faced hammer to lightly
tap shaft into housing.
26. Perform “Fluid Pressure Sensor (FPS) Installation” on
page 159.
To Next Page
Loading...
