2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
121
TRSM0950 Disassembly/Assembly | Rear Housing Assembly Disassembly/Assembly
11. Remove Reaction Plate Alignment Pins (RR1091TR).
12. For Dual PTO transmissions, remove the Rear PTO
Lube Tube 8 mm cap screw and remove tube.
13. Place Rear Housing in press with Output Shaft up.
CAUTION: Rear Housing with the Planetary Output
Shaft Assembly weighs approximately 60 lbs. Keep fin-
gers clear of pinch point between Rear Housing and
other surfaces. Dropping Rear Housing could result in
component damage and/or personal injury.
NOTICE: Place soft material under Planetary Output
Shaft Assembly to cushion removal from Rear Hous
-
ing.
NOTICE: Support the Rear Housing to avoid damaging
the housing and sealing surface.
14. Press Planetary Output Shaft Assembly out of Rear
Housing.
15. Remove Rear Housing and Planetary Output Shaft
Assembly from press.
CAUTION: Rear Housing with the Planetary Output
Shaft Assembly weighs approximately 60 lbs. Keep fin-
gers clear of pinch point between Rear Housing and
other surfaces. Dropping Rear Housing and Planetary
Output Shaft Assembly could result in component
damage and/or personal injury.
!
!
To Next Page
Loading...
