126
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Rear Housing Assembly Disassembly/Assembly | Disassembly/Assembly TRSM0950
17. Install Range Assembly Removal & Installation Tool
(RR1065TR) into Sun Gear groove.
CAUTION: Failure to properly secure tool could result
in component damage or personal injury.
NOTICE: Fully seat tool into groove and hand tighten
until tool is secure.
18. Lift Range Synchronizer Assembly with Range Assem-
bly Removal & Installation tool (RR1065TR).
CAUTION: Range Synchronizer Assembly weighs
approximately 70 lbs. Failure to properly secure and lift
the assembly may result in component damage, seri
-
ous injury or death.
NOTICE: Use an appropriate lifting device to safely lift
component.
19. Install and hold Shift Rail E to Range Synchronizer
Assembly.
Note: Ensure the notched end of Shift Rail E is facing
up.
20. Lower the Range Synchronizer Assembly and Shift Rail
E into Rear Housing.
Note: Align Range Synchronizer Assembly to the Reac-
tion Plate Alignment Pins (RR1091TR) and Shift Rail E
into Rear Housing.
Note: Rotate Sun Gear to ease installation.
21. Remove Range Assembly Removal and Installation
tool (RR1065TR).
To Next Page
Loading...
