138
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Rear Bearing Cover Installation | Installation TRSM0950
Procedure – Installation
1. Clean the sealing surfaces on the transmission and
Rear Bearing Cover with Gasket Remover.
NOTICE: Do not use abrasive scrapers or powered
tools to clean sealing surfaces or sealing surfaces may
be damaged and leak.
2. Inspect threaded bolt holes for debris and clean if nec-
essary.
NOTICE: Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
3. Slide the Output Shaft Thrust Washer over the output
shaft and seat it against the Output Bearing.
4. Slide the O-ring over the output shaft and seat it
again
st the Output Shaft Thrust Washer.
To Next Page
Loading...
