2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
139
TRSM0950 Installation | Rear Bearing Cover Installation
5. Apply Gasket Sealant to the rear housing as shown in
the pattern
below.
NOTICE: Ensure there
is nothing in the threaded bolt
holes
or the transmission may be damaged when
cap
screws are tightened.
6. Slide the Rear Bearing
Cover over the output shaft.
Note: Align the two pry points
at 12 and 6 o’clock posi-
tions.
7. Install 8 Rear Bearing Cover 13
mm Cap Screws and
to
rque to 21-25 Nm (16-19 lb-ft) in a criss-cross pat-
tern.
8. Slide
the Wear Sleeve and Dust Cover over the output
shaft.
9. Per
form “Oil Fill Procedure” on page 213.
To Next Page
Loading...
