142
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Output Yoke Installation | Installation TRSM0950
Procedure – Installation
1. Clean the mating surfaces and splines on the output
shaft and Output Yoke.
2. Slide the Output Yoke over the output shaft.
Note: The Output Yoke may require to be driven on due
to an interference fit.
3. Install the Retainer Plate and a new 27 mm Retainer
Bolt and torque to 617-690 Nm (455-508 lb-ft).
WARNING: A new Retainer Bolt is required during Out-
put Yoke installation. A used Retainer Bolt could loosen
during operation and may result in major vehicle com
-
ponent damage, severe injury or death.
To Next Page
Loading...
