144
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Lower Countershaft Cover and Inertia Brake Installation | Installation TRSM0950
Procedure – Installation
1. Clean sealing surfaces on the Clutch Housing and Iner-
tia Brake Housing.
2. Install the Inertia Brake Cover and Housing as an
assembly over the Lower Countershaft, rotate the
assembly to align the Friction Discs to the Lower
Countershaft splines and seat the assembly to the
clutch housing.
3. While holding the Inertia Brake Housing to the clutch
housing, remove the Inertia Brake Cover.
NOTICE: Ensure the Friction Discs are splined to the
lower countershaft and Wear Guides are fully seated.
4. Install the Return Spring into the Lower Countershaft.
5. Install the Piston Pin into the Lower Countershaft.
6. Install the Inertia Brake Cover onto the housing.
To Next Page
Loading...
