2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
145
TRSM0950 Installation | Lower Countershaft Cover and Inertia Brake Installation
7. Install the 6 13 mm cap screws and torque to 21-25
Nm (16-19 lb-ft) in a criss-cross pattern.
8. Insert air line in push-to-connect fitting on the Inertia
Brake Cover.
9. Perform “Release Bearing and Clutch Release Yoke
Installation” on page 167.
10. Perform “Transmission Installation” on page 211.
Note: Complete all Service Routines or transmission
performance will be degraded.
To Next Page
Loading...
