148
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Cover Installation | Installation TRSM0950
Procedure – Installation
1. Clean sealing surfaces on the clutch housing and Input
Shaft Cover.
2. Slide the Input Shaft Cover over the Input Shaft.
Note: Align “TOP” at 12 o’clock.
3. Install the 7 Input Shaft Cover 13 mm cap screws and
torque to 21-25 Nm (16-19 lb-ft) in a criss-cross pat
-
tern.
4. Perform “Release Bearing and Clutch Release Yoke
Installation” on page 167.
5. Perform “Transmission Installation” on page 211.
To Next Page
Loading...
