160
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Fluid Pressure Sensor (FPS) Installation | Installation TRSM0950
Procedure – Installation
1. Inspect the Fluid Pressure Sensor (FPS) and O-ring for
damage. If damaged, replace the FPS.; O-ring is ser
-
viced with sensor.
2. Install the Transmission FPS into the Main Housing and
torque to 19-23 Nm (14-17 lb-ft).
3. Connect and latch the OEM 3-Way Transmission FPS
Connector.
To Next Page
Loading...
