168
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Release Bearing and Clutch Release Yoke Installation | Installation TRSM0950
Procedure – Installation
1. Install the upper Release Yoke socket over the rod end
of the Linear Clutch Actuator (LCA) and press until
attached.
2. Install the lower Release Yoke socket over the lower
pivot on the clutch housing and press until attached.
3. Slide the Release Bearing over the input shaft and into
the Release Yoke.
4. Push the upper end of the Release Yoke back until it
locks to reset the LCA.
5. Perform “Transmission Installation” on page 211.
Note: Complete all Service Routines or transmission
performance will be degraded.
To Next Page
Loading...
