192
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
8-Bolt PTO Cover Installation | Installation TRSM0950
Procedure – Installation
1. Clean the sealing surface on the transmission and
8-Bolt PTO cover with Gasket Remover.
NOTICE: Do not use abrasive scrapers or powered
tools to clean sealing surfaces or sealing surfaces may
be damaged and leak.
2. Inspect threaded bolt holes for debris and clean if nec-
essary.
NOTICE: Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
3. Apply Gasket Sealant to Main Housing as shown in pat-
tern below.
NOTICE: Ensure there is nothing in the threaded bolt
holes or the transmission may be damaged when cap
screws are tightened.
4. Install the 8-Bolt PTO Cover onto Main Housing with 8
18 mm cap screws and torque to 69-81 Nm (51-60
lb-ft) in a criss-cross pattern.
5. Perform “Oil Fill Procedure” on page 213.
To Next Page
Loading...
