208
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Clutch Installation | Installation TRSM0950
4. Align the Clutch Cover to the flywheel Alignment Pins
and insert the Clutch Alignment Shaft (RR1087TR) into
the Pilot Bearing.
5. Slide the Clutch Cover (and Driven Disc) on to the fly-
wheel until seated and install 6 Clutch Cover cap
screws finger tight.
CAUTION: Use only M10 x 1.5 x 80mm, minimum
class 10.9, flange type fasteners for the Clutch Cover
cap screws.
6. Remove the 2 Alignment Pins (RR1063TR-3), 4
stand-off bolts (RR1063TR-4) and straps (if equipped)
from the Clutch Cover.
7. Install 6 remaining Clutch Cover cap screws finger
tight.
8. Torque Clutch Cover cap screws 1 through 4 to 30 Nm
(23 lb-ft) as shown in the torque sequence below.
CAUTION: Reference cap screw call out images for
proper torque sequence. Failure to follow the torque
sequence may result in component damage.
9. Torque Clutch Cover cap screws 5 through 12 to 30
Nm (23 lb-ft) as shown in the torque sequence below.
To Next Page
Loading...
