224
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Disassembly/Assembly using Input Shaft Press (RR1085TR) | Appendix TRSM0950
12. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR) and Input Shaft Cup (RR1087TR-6)
onto Input Bearing.
13. Rotate jack screw to press Input Shaft Bearing out of
Clutch Housing.
14. Remove 4 cap screws, washers, nuts and Input Shaft
Press (RR1085TR) from Clutch Housing.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch points between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
To Next Page
Loading...
