2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
225
TRSM0950 Appendix | Input Shaft Disassembly/Assembly using Input Shaft Press (RR1085TR)
Procedure - Assembly
1. Place Input Shaft Press (RR1085TR) on the flywheel
housing side of the Clutch Housing.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch point between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
2. Install and hand tighten 4 (2 inch 7/16 inch Grade 8 or
50.8 mm M12 Grade 10.9) cap screws, washers and
nuts to attach press to housing.
3. Place Input Shaft Bearing Removal and Installation
Tool (RR1075TR), Input Bearing Driver (RR1049TR)
and Input Shaft Cup (RR1087TR-6) onto Input Bearing.
4. Rotate jack screw to press Input Shaft Bearing into
Clutch Housing.
NOTICE: Do not over press bearing into Clutch Hous-
ing. Over pressing could result in component damage.
5. Remove Input Shaft Bearing Removal and Installation
Tool (RR1075TR), Input Bearing Driver (RR1049TR)
and Input Shaft Cup (RR1087TR-6).
6. Verify Input Bearing is fully seated in Clutch Housing.
7. Install Front Bearing Capture Plate (RR1085TR-7) to
the Clutch Housing using the Input Shaft Cover
threaded mounting holes and hand tighten 4 plate cap
screws with a 6 mm hex key.
8. Torque cap screws to 21-25 Nm (16-19 lb-ft) in a
criss-cross pattern.
To Next Page
Loading...
