20
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Clutch Removal | Removal TRSM0950
Procedure – Removal
1. Remove the 4 center 15 mm Clutch Cover cap screws
from each of the 3-bolt groups.
WARNING: Clutch weighs approximately 125 lbs. Fail-
ure to properly secure the Clutch Alignment Shaft to
the clutch jack may result in clutch damage, severe
injury or death.
2. Install and hand tighten the 4 stand-off bolts
(RR1063TR-4) in place of the removed Clutch Cover
cap screws.
3. Insert the clutch jack-mounted Clutch Alignment Shaft
(RR1087TR) into the clutch diaphragm spring and pilot
bearing.
WARNING: Clutch weighs approximately 125 lbs.
Dropping clutch may result in damage to clutch, seri-
ous injury or death.
4. Remove the 8 remaining 15 mm Clutch Cover cap
screws.
NOTICE: Do not remove the 4 stand-off bolts.
5. Remove the Clutch Cover and Driven Disc from the fly-
wheel.
6. Remove the pilot bearing if the clutch assembly or the
input shaft wear sleeve are being replaced.
!
To Next Page
Loading...
