2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
227
TRSM0950 Appendix | Input Shaft Disassembly/Assembly using Input Shaft Press (RR1085TR)
14. Rotate jack screw to press Input Shaft into Clutch
Housing until fully seated.
NOTICE: Do not over press Input Shaft into Clutch
Housing. Over pressing could result in component
damage.
15. Remove 4 cap screws, washers, nuts and Input Shaft
Press (RR1085TR) from Clutch Housing.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch points between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
16. Remove Front Bearing Capture Plate (RR1085TR-7)
from Clutch Housing.
17. Install Input Shaft Snap Ring.
NOTICE: A new snap ring is required when reinstalling.
A used snap ring may detach from Input Shaft and
result in transmission component damage.
Note: The snap ring will not install if Input Shaft is not
fully seated into Input Shaft Bearing.
To Next Page
Loading...
