2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
243
TRSM0950 Appendix | Change Log
Change Log
Date Description
March 2019 Updated Specialty Tools, Main Shaft and Countershaft Installation, Clutch Ins
tallation, Rear Bearing Cover
Removal, Input Shaft Disassembly/Assembly, Rear Bearing Cover Installation
November 2018 Updated Warnings and Cautions section and p
roduct safety information throughout manual
Updated Inspection Precautions adding torque
specifications
Updated Roadranger Specialty Tools adding tools for new sections
Added Rear Housing Removal, Installation and Disa
ssembly/Assembly sections
Added Main Housing Removal and Installation sections
Added Main Shaft and Countershaft Removal and In
stallation, sections
Added 4 Bolt PTO Cover Removal and Installation sections
Added 8 Bolt PTO Cover Removal and Installation sections
Added Harness Bracket Removal and Installation sections
Added Oil Pump Removal and Installation sections
Added Main Shaft Disassembly/Assembly section
Added Input Shaft Disassembly/Assembly section
Added Main Housing Disassembly/Assembly section
Added Clutch Housing files Disassembly/Assembly section
Added Input Shaft Disassembly/Assembly using Input Sh
aft Press (RR1085TR) section to the Appendix
Removed table from Lubrication Specifications detailed inform
ation is in TCMT0021 Eaton Lubrication Product
Specification Manual
June 2018 Updated LCA Installation and Removal
April 2018 Updated Lubrication Specifications
Updated Special Tools in Transmission Removal and Transmission
Installation
Added Recycling section
March 2018 Updated all procedures with fastener sizes
Added Fluid Pressure Sensor (FPS) Removal and Installation
procedures
Added Manually Vent LCA procedures
Added Input Shaft Cover Disassembly/Assembly
Removed Transmission Specifications page
from General Information section
To Next Page
Loading...
