2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
53
TRSM0950 Removal | Rear Housing Assembly Removal
9. At the 3 Rear Housing Threaded cap screws, apply
paint marks on the Rear Housing to identify location.
10. Remove 21 Rear Housing and 3 threaded 16 mm cap
screws.
11. Install and hand tighten 2 Rear Housing Alignment
Pins (RR1090TR) 180-degrees apart.
NOTICE: Failure to install alignment pins results in
transmission component damage.
12. Separate the Rear Housing from the Main Housing at
the 2 pry points.
To Next Page
Loading...
