60
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Removal | Removal TRSM0950
Procedure - Removal
1. Perform “Transmission Removal” on page 17.
2. Perform “Transmission Control Module (TCM)
Removal” on page 13.
3. Perform “Mechatronic Transmission Module (MTM)
Removal” on page 27.
4. Perform “Release Bearing and Clutch Release Yoke
Removal” on page 31.
5. Perform “Output Speed Sensor Removal” on page 23.
6. Perform “Harness Bracket Removal” on page 49.
7. Perform “Output Yoke Removal” on page 43.
8. Lift transmission vertically onto a bench with on open-
ing to allow the input shaft to pass through and clutch
housing to sit flat on bench.
WARNING: Transmission weighs approximately 550
lbs. Keep fingers clear of pinch point between trans-
mission and other surfaces. Dropping transmission
may result in major vehicle component damage, severe
injury or death.
NOTICE: Use an appropriate lifting device to safely lift
component.
9. Perform “Rear Housing Assembly Removal” on
page 51.
10. Remove 2 Rear Housing Alignment Pins (RR1090TR).
11. Perform “Oil Pump Removal” on page 57.
!
To Next Page
Loading...
