76
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Output Seal Assembly | Disassembly/Assembly TRSM0950
Procedure – Assembly
1. Place the Rear Bearing Cover on a flat clean surface the
pry points down.
NOTICE: A new Rear Bearing Cover is required when
replacing the Output Seal to ensure no leaks occur
between the cover and new seal.
2. Place the Output Seal Driver (RR1001TR-8) onto the
Output Seal Driver Handle (RR1001TR-2).
3. Place the Output Seal onto the Output Seal Driver
(RR1001TR-8).
4. Install the Output Seal and driver assembly into the
Rear Bearing Cover and drive until the seal is seated
against the cover.
NOTICE: Fully seat Output Seal into Bearing Cover.
To Next Page
Loading...
