90
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Cover Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure – Assembly
1. Place the Input Shaft Cover on a bench and place the
Input Shaft Seal over the seal bore.
2. Place Output Shaft Installer/Input Shaft Seal Driver
(RR1070TR) onto the Input Shaft Seal and drive until
seal is seated into the cover.
Note: Fully seat Seal into Input Shaft Cover
3. Install Input Shaft Cover O-ring.
To Next Page
Loading...
