Eaton Endurant - Page 98

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
95
TRSM0950 Disassembly/Assembly | Main Shaft Disassembly/Assembly
Procedure - Assembly
1. Place Main Shaft vertically on a clean flat surface.
CAUTION: Secure Main Shaft Assembly while on flat
surface to avoid unexpected movement. Failure to
properly secure Main Shaft Assembly could result in
component damage and/or personal injury.
2. Install and rotate the first standard Main Shaft Washer
(6.525 mm) onto Main Shaft.
3. Install a 5/32 OD air line into the main shaft spline to
align and hold washer in place.
!