Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 42
Chapter 6 LCD Interface Operation
This chapter contains operation information for the Eaton PDUs, including:
l
LCD display and control button functions
l
Menu selections
NOTE The LCD language is configurable. See language settings in“Language Submenu”
on page 59.
LCD Display and Control Buttons
The ePDU has a four-button, graphical LCD display (see Figure 37). Use the control buttons to change the
screen display, retrieve specific performance data, or change configuration values. The display view can also
change automatically. For example, the display changes to show active alarms as they occur, or particular
displays update due to a change in operating state.
A backlight is used to light up the display with white and blue:
l
The backlight turns off automatically when no button has been pressed for 15 minutes and there is no active
alarm.
l
Any active alarm will cause the backlight to turn on automatically.
A red blinking background indicates that an alarm is active.
Figure 37. LCD Display
Table 5 summarizes how to use the control buttons.
Table 5. Control Buttons
Button When on the Main Menu When in Screensaver mode When in Menu mode
Returns to the Start-up screen. Returns to the previous display screen
before entering the screensaver mode.
Returns to the previous display screen.
Opens the selected menu.
NOTE: Wh
en menu items are
highlighted, they are selected.
Returns to the previous display screen
befo
re entering the screensaver mode.
Signals that you want to set the values as
displayed on the screen.
NOTE: O
n information screens, this button
has no action.
Scrolls up or down through the list of
menu items.
Returns to the previous display screen
befo
re entering the screensaver mode.
Scrolls up or down to the next screen or
value.
To Next Page
Loading...
