EasyManua.ls Logo

Eaton ePDU G3 - Page 89

Eaton ePDU G3
155 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Serial Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 81
PDU.Input[2].Statistic[5].ModuleReset Command Command to Reset the stat, this command does not put 0
in the counter but saves the current value of Energy timer
into the data ...Reset.Energy.
- RW
PDU.Input[2].Statistic[5].Reset.Energy Measure Energy saved at the instant the user resets the stat. Wh RO
PDU.Input[2].Statistic[5].Reset.Time Measure Timestamp saved at the instant the user resets the stat. s RO
PDU.Input[2].Type Constant Enum all the kind of Input plug that a ePDU can have :
1=?
- RO
PDU.MeasurementBoard.Gateway.Address HideMeasure Address of the teridian module to be accessed. - RW
PDU.MeasurementBoard.Gateway.Command HideMeasure Write: command to the Gateway
0: None
1: Read
2: Write
Read: return the CR of last command to the Gateway:
0: Success
<> 0 , Access failed for the following reasons:
1: Command Unknown.
2: Gateway not enabled.
3: Address out of range.
4: Register out of r.
- RW
PDU.MeasurementBoard.Gateway.Count HideMeasure Number of 32 bits data to be read or write in consecutive
READ or WRITE request. 1 to 8.
- RW
PDU.MeasurementBoard.Gateway.Register HideMeasure Address of the register to be read or write. - RW
PDU.MeasurementBoard.Gateway.Switchable HideMeasure 0: The gateway is disabled.
1: The gateway is enabled.
- RW
PDU.MeasurementBoard.Gateway[x].Value HideMeasure 1 up to 8 consecutive register values can be read or write
with the gateway in one request.
NOTE: Follow these steps to read registers from the board:
1. Write 1 in Command
2. Read Command, check it is 0
3. Read the data that had been read into Value
- RW
PDU.MeasurementBoard[x].PresentStatus.CommunicationLost Measure Communication status with the acquisition card ICM &
SM:
0: Communication OK
1: Communication failed.
- RO
PDU.OutletSystem.Outlet.Count Constant Total Number of outlets - RO
PDU.OutletSystem.Outlet[x].ActivePower Measure Active Power Measurement dW RO
PDU.OutletSystem.Outlet[x].ApparentPower Measure Apparent Power Measurement dVA RO
Table 8. ePDU CLI Objects (Continued)
XML Object Name Type Description Unit Access

Table of Contents

Other manuals for Eaton ePDU G3

Related product manuals