EXTERNAL BYPASS SWITCH INSTALLATION
Eaton FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide S 164201403 Rev B
www.eaton.com/powerquality
33
C A U T I O N
To prevent electrical shock or damage to your equipment, verify that the AC input is OFF at
the service panel and the bypass and AC disconnect switches are in the OFF position before
you connect any wires to the bypass switch terminal strip.
8. Find the terminal strip inside the bypass switch. Using the label on
the back of the switch's lower front cover panel, wire the terminal
strip and tighten all connections securely. Use copper wire and the
appropriate wire size for the current. See Figure 7 for sample
terminal strip labels.
BPE-01
BPE-02,
BPE-04,
and
BPE-05
Figure 7. External Bypass Switch Terminal Strip Labels
To Next Page
Loading...
