212
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Shift Bar Housing | Disassembly and Assembly TRSM0940
13. Install the block and yoke lock screws, tighten and lock
wire securely.
14. After all lock screws and safety wire have been
installed, flip the Shift Bar Housing over.
15. Install the three tension balls and springs into the
bores on the top of the Shift Bar Housing.
16. Install the Detent Spring Caps over the springs in each
bore; thread in and torque 12–15 lb-ft.
To Next Page
Loading...