2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
49
TRSM0940 Auxiliary Section Service Procedures | VCS/VMS Auxiliary Section Removal and Disassembly
22. Remove the six cap screws that fasten the Output Shaft
bearing cover tot eh Auxiliary Section.
23. Remove the Output Shaft bearing cover.
24. Inspect the Rear Bearing Cover oil seal for damage.
Remove if damage is found.
25. Remove the rear portion of the tapered bearing which
should be free sitting in the race in the case. Also
remove the one piece race from it’s bore.
To Next Page
Loading...