2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
169
TRSM0940 Removal and Installation | Oil Pump and Lube Tube Installation
Auxiliary Section Installation
1. Ensure that the Auxiliary Counter Shaft Support Straps
are still installed and all three cap screws are snug.
2. Install new Gasket on the Main Case.
3. Using an overhead crane, lift the Auxiliary Case assem-
bly and line up the two holes in the Auxiliary Case with
the Transmission Main Case alignment pins. Push the
case forward toward the Transmission Main Case.
Note: Verify the Auxiliary Counter Shafts are still timed
to the Auxiliary Reduction Gear before installing. This
will allow for easier installation and timing to the Auxil-
iary Drive Gear.
To Next Page
Loading...