2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
89
TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Countershaft Installation
3. Position a new gasket between the Splitter Cylinder
and the Auxiliary Case Housing bore. Install the Splitter
Cylinder.
4. Install new O-rings on the ID and OD of the piston.
Lubricate with silicone.
5. Install new O-ring on the end of the yoke bar inside of
the cylinder housing.
6. Install the piston into the Splitter Cylinder with the
recessed side facing the rear of the transmission.
7. Secure piston with the 3/4 lock nut. Torque to 30-36
lb-ft (41-49N•m).
To Next Page
Loading...