Eaton FO-20E318B-MXP - Replacing Input Shaft without Disassembling the Main Case or Removing Clutch Housing

2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
99
TRSM0940 Removal and Installation | Input Shaft
Replacing Input Shaft without Disassembling
the Main Case or Removing Clutch Housing
1. Remove the six cap screws fastening the Front Bearing
Cover to the Transmission Main Case.
2. If present, remove and discard the rubber seal on the
Input Shaft. This rubber seal is only used to seal the
Transmission during shipment.
3. Remove the snap ring from the Input Shaft.
4. Using a soft maul drive the Input Shaft towards the
rear of the Transmission Case as far as possible. Pull
the Input Shaft forward.
5. Install the Input Shaft Bearing Remover and remove
the bearing from the Transmission Main Case.
Note: A pry bar or screwdriver may also be used to
remove the Input Shaft Bearing.