148
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Electronic Clutch Actuator (ECA) Speed Sensor | Removal and Installation TRSM0940
ECA Speed Sensor Removal
1. Disconnect the Transmission Harness from the Elec-
tronic Clutch Actuator (ECA) Speed Sensor.
2. Using a 6-point reverse torx bit, remove the bolt from
the retaining clip.
3. The clip will not remove from the speed sensor.
Remove the ECA Speed Sensor with O-ring, from the
Clutch Housing.
ECA Speed Sensor Installation
Important: Clean the mounting surface on the housing and
remove any burrs or sharp edges.
Important: Lubricate the O-ring with Eaton Fuller silicone
71214 or equivalent.
1. Using a smooth twisting motion; fully insert the Elec-
tronic Clutch Actuator (ECA) Speed Sensor in the
Transmission Clutch Housing on the lower left hand
side.
2. Using a 6-point reverse torx bit, install the retaining
bolt and tighten 7–9 lb-ft (9–12 N•m).
To Next Page
Loading...