Eaton FO-22E318B-VXP - Main Case Main Shaft with Low Force Gearing Disassembly

220
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Main Case Main Shaft without Low Force Gearing Assembly | Disassembly and Assembly TRSM0940
6. Install the 2nd/3rd Sliding Clutch. Make sure the wide
slot on the sliding clutch aligns with the keyway.
7. Install the stepped washer. Rotate the stepped washer
and push the air line through.
8. Install 2nd Gear and the no-burn washer. Rotate the
no-burn washer and push the air line through.
9. Install 1st Gear and the stepped washer. Rotate the
stepped washer and push the air line through.
10. Install the 1st/Reverse Sliding Clutch. Align the wide
slot on the sliding clutch with the keyway.