Eaton FO-22E318B-VXP - VCS;VMS Auxiliary Section Assembly and Installation

48
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
VCS/VMS Auxiliary Section Removal and Disassembly | Auxiliary Section Service Procedures TRSM0940
18. Align the Splined Washer along the Coupler Shaft.
Remove the Coupler from the Range Gear and Washer.
19. Remove the splined washer from inside the Low Range
Gear (Reduction Gear)
20. Remove the sliding clutch and Deep Reduction Yoke
Assembly.
21. Using a soft bar and maul, drive the Output Shaft for-
ward and through the Rear Bearing Assembly.