2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
75
TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Section Removal and Disassembly
18. Remove the Range Synchronizer Assembly from the
Output Shaft
Note: For disassembly and assembly of the Syn-
crhonizer, please refer to the “How to disassemble the
Sychronizer Assembly” section.
19. Using a soft bar and maul, drive the Output Shaft for-
ward and through the Rear Bearing Assembly.
20. Remove the six cap screws that fasten the Output Shaft
bearing cover to the Auxiliary Section.
21. Remove the Output Shaft bearing cover.
22. Inspect the Rear Bearing Cover oil seal for damage.
Remove if damage is found.
To Next Page
Loading...