Eaton FOM-16E310C-LAS - Main Case Main Shaft Disassembly with Low Force Gearing

2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
221
TRSM0940 Disassembly and Assembly | Main Case Main Shaft without Low Force Gearing Assembly
11. Install the larger reverse washer. Rotate the washer
and push the air line through.
12. Install the key and push the air line down through the
Main Shaft until it contacts the roll pin.
13. Install the Reverse Gear on the Main Shaft and slide it
over the sliding clutch with the snap ring groove facing
rearward for installation.