Eaton FOM-16E310C-LAS - Output Yoke Installation

To Next Page

To Previous Page

2022.10.7

TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Countershaft Installation

Output Yoke Installation

1. Install the Output Yoke. Ensure yoke is properly seated

against Output Shaft.

2. Secure the Output Yoke with the 2 retaining bolts.

Torque to 84–92 lb-ft (113–124 N•m).

Main Page

General Information2
Table of Contents3
Warnings & Cautions4
How to Use this Manual5
Transmission Overview6
Serial Tag Information and Model Nomenclature9
Timing Procedures11
Preventive Maintenance13
Assembly and Disassembly Precautions14
Auxiliary Section Service Procedures16
LAS/VAS Auxiliary Section Removal and Disassembly - in Chassis16
LAS/VAS Auxiliary Section Removal and Disassembly20
LAS/VAS Auxiliary Section Assembly and Installation30
VCS/VMS Auxiliary Section Removal and Disassembly - in Chassis41
VCS/VMS Auxiliary Section Removal and Disassembly43
VCS/VMS Auxiliary Section Assembly and Installation54
MHP/MXP/VHP/VXP Auxiliary Section Removal and Disassembly68
MHP/MXP/VHP/VXP Auxiliary Section Assembly and Installation81
MHP/MXP/VHP/VXP Auxiliary Countershaft Installation85
Removal and Installation98
VCS/VMS Combination Valve98
Input Shaft101
Clutch Housing105
Shift Bar Housing107
Reverse Switch110
Electronic Clutch Actuator (ECA)113
Low Capacity Inertia Brake (LCIB)117
Release Yoke and Cross-Shaft(S)119
Cobra Lever124
Eaton Push Button Shift Control Device (PBSC)126
Transmission Harness128
Transmission Electronic Control Unit (TECU)130
X-Y Shifter134
Range Valve138
Output Shaft Speed Sensor141
Input Shaft Speed Sensor144
Main Shaft Speed Sensor147
Electronic Clutch Actuator (ECA) Speed Sensor150
Rail Position Sensor153
Gear Position Sensor156
Oil Pump and Lube Tube Installation159
VCS/VMS Combination Cylinder175
Range Cylinder LAS/VAS Model183
MHP/MXP/VHP/VXP Range Cylinder189
MHP/MXP/VHP/VXP Splitter Cylinder195
MHP/MXP/VHP/VXP Splitter Gear Bearing201
Range Synchronizer205
Shift Bar Housing210
Main Case Main Shaft Without Low Force Gearing Disassembly216
Main Case Main Shaft Without Low Force Gearing Assembly221
Main Case Main Shaft with Low Force Gearing Disassembly226
Main Case Main Shaft with Low Force Gearing Assembly232
Main Case Disassembly and Lubrication Tube Removal238
Appendix247
Tool Specifications247
Oil Leak Inspection Process251
Inspection Procedure252
Power Flow254
Torque Specifications258
Lubrication Specifications262
Clutch Greasing Guidelines263
Grade Sensor Calibration264

Eaton FOM-16E310C-LAS - Output Yoke Installation

Table of Contents

Other manuals for Eaton FOM-16E310C-LAS

Related product manuals