Eaton FS-4005C - INSTALLATION - SHIFTING CONTROLS; Installation of Shift Bar Housing and Gear Shift Lever

REASSEMBLY· TRANSMISSION
Installation of Mainshaft (cont.)
37. Pl aoo 1ra nsmission In a vertlcal posiUon o.s shown
Ins ta ll yoke and nu t. Tighten the yoke nut 10 te<:ommendect
torqut. Rotato !ht lnpU1 shattstxt1 mes ineadl d r0t.1lon to
seal the bonrings and rsce.s. .
38. -•cNllndcalO'as.,_.,onlhe _ _,
Pry on 1119 C>Jtput llange and read 1l1e c>aJ _,.,, to get
.,... mainst\olrt e nd p&ay End play muse be bet'ktlen ooe
012 (0 20 ·0.30mm) Addsllims1olhefrontboarlngoaver
lor
more Ind play or remove shims for less end pl ay , After
1he 00t1ec 1 ond p&ay is set re m ove lhe fro nt boanng cover
and tlhlms . Coo. I bo lh s.dos of the &lilms w l11l a hghl ooa l
al LOCl<le #610. l ns t otl tOe shims and 1 ho hont boar1 ng
oove1 on 1he transmission case Coal the fron t bearing
OO\+&r cap1e11W1 with LOCllt & .-262, Install 1n 1ho tronl
beanno oove1 . 8"d tighten to Ole reoomtnllnded totque