Eaton FS-6105 - Page 36

DISASSEMBLY - TRANSMISSION
••
3. Us l ng a s ll de hammof' remove reyerse i dler shaft .
Remove localing ba ll once ii is exposed (Inset) .
•
•
-
4. Remove reverse Idler, bearings, sp<ltcer and lhrvsi
washers.
••
6. Move countershafc assembly to the rear and lift t1
from 1h& case.
••
6. If countershafl Iron! bearing race ts 1o be re·
placed, drive bore pl ug through front of transmis·
sion and drive 1he race to Che rear toward the
inside of lhe case.