Eaton FS-6105 - Page 42

REASSEMBLY - TRANSMISSION
•
•
•
•
Cl·ll
12. 1 ns1an bearings and spacer In reverse Id l er gear
(Inset) and position gear In housi ng
NOTE: Gear can be Insta ll ed ei ther way.
-
)
•••
1 3. lnsett I dl er shaft through case and Idler gear
bearings. Line
up notch in shafl w it h notch In
case, insta ll l ock ba ll. and dr i v& shaJI Into posl·
t ion (I nset).
<O
I
14. In sta ll eounlershafl rear bearing race into cas.e
BS Sh0\\10.
.:..... .... .
15. Tempor ar il y I ns tall n ew sh ims i nto bearing re-
tal ner (Inset). lnstaill retainer. Tighten set screws
10 5-10 l bs . fl {7-14 Nm>.
NOTE: Lube ho le in reta i ner must fine up w it h
lub ho le in Ca.$e .