Eaton FS-6105 - Page 50

REASSEMBLY - TRANSMISSION
.. ,. t .....
24. If previously removf,KI Install teaf bearing ra,co
(inset) . Temp o1arily intilall shims and roar
bearing cover. Tighten nuts to 80-70 lbs. IL (81·95
Nm),
NOTE: Top of rear bearing cover Is marked lor
prope' Instal latio n.
-
• •
25. Pi ece trensm i ss i on in a ver1ica1 posillon ilS
shown . lns1atl yoke and nu t. To rque yoke nul to
31J0.350 lt>s . It. {407-475 Nm). t:totate Input shafl
and malnshaf t lo seat bearings and 1aces.
••
• •
• •
26. Position dlaJ I ndicator as shown. Pry up on out ·
put shatl to measure end play. End play must be
se1 et .002·.008 (0.05-0.20 mi n). Add shims for
more end play, remove shims tor less end play.
NOTE: Once end plaiy fs correc t remove yoke
and rear bearing cover and eppfy a li ght coat of
Lo cti te 510 to both side .s ol shims
•
•
27. If ne\v oil aei!I is required, install u s1ng a llanQ:d -
driver . Coi!t outer diameter of o il seal with L OC ·
ti1e 510 •