Eaton Fuller FSO-2405 - Page 102

102
Rear Section Assembly
3
Rear Section 2nd Ed. 02/07 FSO-2405
FSO-2405/22
FSO-2405/21
8
7
FSO-2405/23
6
FSO-2405/20
9
6. Install the 5th speed gear on the mainshaft.
7. Install the retaining ball of the countershaft 5th
speed gear thrust washer on the countershaft.
Apply grease to hold the ball in place.
8. Install the 5th speed gear thrust washer on the
countershaft. Make sure to set correctly the
retaining ball into the washer slot.
NOTE: Install the thrust washer counterbore
side up (facing the needle bearing).
9. Install the two needle bearings of 5th speed
gear on the countershaft.