Eaton Fuller FSO-2405 - Page 121

121
Front Section Disassembly
4
FSO-2405 2nd Ed. 02/07 Front Section
FSO-2405/106
FSO-2405/105
FSO-2405/104
16
18
20
16
19
16. Use two tubular tools and press the late
installed set of components of the mainshaft.
Make sure to align the synchronizer ring lugs
with hub key slots.
WARNING! Apply force to bearing inner
race. NEVER apply force to the bearing
cage.
NOTE: See “Special Tools”, Ref. E010001,
E010002.
17. Make sure the pressing procedure was
successfully: disengage the synchronizer and
position it between the 3rd and 4th speed gears.
In this condition, the gears should run free.
Manishaft
18. Install the 3rd/4th synchronizer hub retaining
snap ring.
19. Position the front bearing cone on the
mainshaft.
20. Press the front bearing cone.
WARNING! Apply force to bearing inner
race. NEVER apply force to the bearing
cage.
NOTE: See “Special Tools”, Ref. E010001.