Eaton Fuller FSO-2405 - Page 125

125
Front Section Disassembly
4
FSO-2405 2nd Ed. 02/07 Front Section
FSO-2405/111
2
FSO-2405/112
1
Shift Yoke Bars
Shift Selecting Bar Assembly
1. The shift selecting bar has two holes
simmetricaly positioned to the bar center to
install retaining roll pins. Thus, the shift
selecting block can be assembled on any bar
end.
2. Install the shift selecting block on the shift bar.
3. Align the shift block with the shift bar matching
the roll pin holes and install the retaining roll
pin. Push the roll pin until it is flush with shift
block hub.
NOTE: See “Special Tools”, Ref. E001045.
NOTE: Replace the roll pin by a new one.
5th/reverse Yoke Bar Assembly
1. Make sure the shift block is properly positioned
regarding the notch at the yoke bar end and
install the shift block on the yoke bar. Notice
that the opposite bar end also has a notch,
shifted 180° from the other, and a hole.
2. Align the shift block with the shift bar matching
the roll pin holes and install the retaining roll
pin. Push the roll pin until it is flush with shift
block hub.
NOTE: See “Special Tools”, Ref. E001045.
NOTE: Replace the roll pin by a new one.