Eaton Fuller FSO-2405 - Reverse Idler Gear Shaft Procedures

126
Front Section Disassembly
4
Front Section 2nd Ed. 02/07 FSO-2405
FSO-2405/69
1
2
FSO-2405/69
2
1
Reverse Idler Gear Shaft
Removal
1. In the intermediate housing, locate the reverse
idler gear shaft retaining capscrew and remove
it.
2. Remove the idler shaft.
Installation
1. Align the shaft hole with the housing hole and
install the idler shaft into the shaft bore.
2. Tighten the retaining capscrew to the proper
torque.
NOTE: Torque = 14-19 N.m (19-26 Lb.ft)