Eaton Fuller FSO-2405 - Assembly

133
Front Section Disassembly
4
FSO-2405 2nd Ed. 02/07 Front Section
FSO-2405/62
1
FSO-2405/63
2
FSO-2405/61
3
FSO-2405/45
4
Reverse Shifting Interlocking System
Assembly
1. Align the interlok pin hole with the housing hole
and install the interlocking mechanism into the
pin bore.
2. Give the spring as much as the tension you
can by winding the spring on the pin and then
set its free end in the housing hole.
3. Install a new roll pin.
NOTE: Use a 4 mm diameter pin punch.
NOTE: Replace the roll pin by a new one.
4. Install a new expansive plug in the housing
hole.
NOTE: See “Expansive Plugs” for
instructions.