147
Front Section Assembly
4
FSO-2405 2nd Ed. 02/07 Front Section
FSO-2405/119
FSO-2405/120
11
12
11. Align the 5th/reverse yoke bar with the bar bore,
with the selecting block longest arm and with
the reverse shifting interlock pin, and install the
yoke bar.
WARNING! Do not apply sealant to both
housing and retaining capscrews by
now! Prior to finishing the transmission
assembly is necessary to check the end
play.
12. Position the shift lug in the gear shift control
tower opening in the intermediate housing, and
install the intermediate housing on the front
housing. The shift lug should be installed on
the shift selecting bar with the cam side facing
right as shown in the picture.
NOTE: If necessary, carefully hit the
housing’s capscrews area with a plastic
hammer to match the housings.
13. Install the intermediate housing retaining
capscrews. Tighten the capscrews crosswise
to the recommended torque.
NOTE: Torque = 19-25 N.m (14-19 Lb.ft)
14. Align the shift lug with the shift selecting bar
matching the roll pin holes and install the
retaining roll pin.
NOTE: See “Special Tools”, Ref. E001045.
E001045
14
To Next Page
Loading...