Eaton Fuller FSO-2405 - Page 152

152
Front Section Assembly
4
Front Section 2nd Ed. 02/07 FSO-2405
FSO-2405/124
31
End Play Adjustment
30. Use the proper drive tool and remove the rear
bearing cups (see “Mainshaft and
Countershaft Rear Bearing Cups - Removal
and Installation”).
WARNING! Be careful to not swap the
adjustment shim pack between
mainshaft and countershaft when
installing.
31. Install the necessary shim pack thickness to
adjust the mainshaft end play in the mainshaft
rear bearing bore and next, install the bearing
cup.
NOTE: Use the proper drive tool to install
the bearing cup (see “Mainshaft and
Countershaft Rear Bearing Cups - Removal
and Installation”).
32. Install the necessary shim pack thickness to
adjust the countershaft end play in the
countershaft rear bearing bore and next, install
the bearing cup.
NOTE: Use the proper drive tool to install
the bearing cup (see “Mainshaft and
Countershaft Rear Bearing Cups - Removal
and Installation”).
FSO-2405/173
30