153
Front Section Assembly
4
FSO-2405 2nd Ed. 02/07 Front Section
FSO-2405/32
FSO-2405/120
FSO-2405/125
35
36
36
33. Remove any remaining sealant material from
housing mounting surfaces.
34. Use either a proper tap or screw and remove
any remaining sealant material from housing
threaded holes.
35. Apply sealant to the front housing mounting
surface. Spread the sealant properly to prevent
leaks.
NOTE:
Use
Eaton E680
sealant.
36. Position the shift lug in the gear shift control
tower opening in the intermediate housing, and
install the intermediate housing on the front
housing. The shift lug should be installed on
the shift selecting bar with the cam side facing
right as shown in the picture.
NOTE: If necessary, carefully hit the
housing’s capscrews area with a plastic
hammer to match the housings.
To Next Page
Loading...